![]() ![]() According to the Arduino PWM Signals, we will fine tune our Speed in RC Control Tab and set it to 2 units. Next we need to Check " SKIP GYRO CALIBRATION AT STARTUP" since it basically wastes 5-10 seconds in configuring and adjusting the algorithm with calibration step, we will skip it since we will have added PPM/ PWM inputs for our Gimbal using Arduino. At minimum, users will want an Arduino compatible microcontroller with a USB cable, a power supply, some hookup wire or jumper wires, and a stepper motor. The driver module is powered by the 5V pin of the Arduino Board. To energise the four coils of the stepper motor we are using the digital pins 8,9,10 and 11. We have used the 28BYJ-48 Stepper motor and the ULN2003 Driver module. This image shows the Arduino Uno R3 Compatible board in Windows 8 Device manager as USB-SERIAL CH340. The circuit Diagram for the arduino stepper motor control project is shown above. Fully compatible with with Arduino Software. We started by connecting the steppers to the CNC shield and then to the Arduino. We need out Gimbal to be very smooth since it is a Hand Held Gimbal so we adjust the PID and Motor Power in Basics Tab of our Software.Īnd Set Power to 60 Units and No of Poles to 15 Poles. Used ATmega328p microcontroller that can be programmed via Arduino software which can be downloaded for free from website. The rope at the other end would have a camera gimbal operated by a. ![]() arduino microcontroller camera photography stepper-motor gimbal camera-slider. ![]() Since we are using a 2 Axis BGC gimbal that comes with Motherboard and developers at basecam have did a wonderful job in developing a Software interface for this Hardware, you can download the software from this link! An Open Source software for a Motorized Arduino based 2-Axis Camera Slider. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |